Signals | HO-Scale | G-Style

G-TYPE, N.Y.C. TRICOLOR SIGNALS

This style of signal was used on the NYC lines and has often been called the NYC style signal.  Because it has no moving parts and therefore low maintenance, many railroads have been substituting the G-Type signal wherever signals need to be updated.  There are 3 different G-Type signals depending on track configurations.  These are modeled in the modern Safetran style signals.  Each of the signals comes with about 12 inches of wire allowing it to be modified for use on a bridge or bracketed tower.

0235 SINGLE TARGET GROUND SIGNAL

0236 SINGLE TARGET GROUND SIGNAL, w/Signal Control Board

0237 SINGLE TARGET GROUND SIGNAL, 4-Pack

This signal is used as an intermediate block signal, at the end of a siding or at a rail crossover. 

0238  DOUBLE TARGET MAST SIGNAL

These signals would be used on the main line where the train had a choice of 2 different routes.  One choice would be the main line and would be displayed on the upper target.  The other would be for a diverting route and would be displayed on the lower target.  Some examples would be approaching a junction, an interlocking, a diverging route or passing siding.

0239 BI-DIRECTIONAL MAST SIGNAL

These signals would be used as intermediate signals on any main line for both directions with no sidings or diversions.  The railroads save time and money to build and maintain the signal by having everything on one mast and ladder.

0234 HO-SCALE SIGNAL CONTROL BOARD

This controller was designed for the HO-Scale, G-Style signals.